Do it yourself

Symptom/Malfunction

Remedy

Checking and replacing fuses

 If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary.
Refer the correct owners manual.

Emergency Engine starting (With Entry and Start system)

 When the key battery is low or when operation fails by electric wave disturbance  the engine, can be started by holding the key over the engine switch while depressing the brake pedal (while depressing the clutch  pedal for M/T models).

Draining the water in the fuel filter

 If fuel system warning light blinks, drain the water using the fuel filter drain plug, under fuel filter housing.
But, if the fuel system warning light remains ON, go to TOYOTA dealer.

When Pre-Collision System malfunction and warning light flashes

 Indicates that the PCS (Pre-Collision System) is temporarily unavailable, possibly due to either of the following:
When an area around the radar sensor or camera sensor being dirty, fogged up or covered with condensation, ice, stickers, etc.
* Clear the dirt, fog, condensation, ice, stickers, etc.
Please refer the correct owners manual to find the location of radar sensor.
When  Radar sensor or camera sensor temperature being outside of its operational range
* Wait for a while until the area around the radar sensor or camera sensor has cooled down sufficiently.

DPF regeneration (Vehicle with DPF system switch)

 1. Stop the vehicle in a safe place.
2. Firmly set the parking brake and shift the shift lever to P (automatic transmission) or N (manual transmission). Release the clutch pedal.
Do not stop the engine. Also, make sure that there are no flammable materials near the exhaust pipe.
3. Press the switch. After pressing the DPF system switch, do not depress the accelerator pedal or the clutch pedal (manual transmission). Depressing the pedal(s) will stop regeneration.
The DPF system warning light and the indicator light on the switch will change from solid or rapid flashing to slow flashing, and the idling engine speed will increase.
Regeneration will take around 20 – 30* minutes to complete.
When the DPF system warning light goes out, the idling engine speed will have finished returning to normal.
* Referee the correct owner’s manual.

If the shift lever cannot be shifted from P

 1. Set the parking brake.
2. Turn the engine switch to the “LOCK” position (vehicles without a smart key system) or off (vehicles with a smart key system).
3. Depress the brake pedal.
4. Remove the shift lock cove cover using flathead screwdriver. To prevent damage to the cover, tip the screwdriver with a rag.
5. Press the shift lock override button while pressing the button on the shift knob.
The shift lever can be shifted while the button is pressed.